T5100 Series of Wall Mount CO2 Transmitters

Patented, Absorption Infrared Gas sensing engine provides high accuracy in a compact low cost package
Patented ABC Logic™ self-calibration system eliminates the need for manual calibration in most applications
Lifetime CO₂ calibration guarantee when using ABC Logic™
Mounting plate with two-piece terminal blocks provide quick, easy wiring
Gas permeable, water resistant CO₂ diffusion filter prevents particulate and water contamination of the sensor
Locking screw secures cover and sensor to the mounting bracket for tamper resistance
Sensors are shipped factory calibrated
Modern enclosure
Low cost
Reliable (20 years of low-cost infrared sensor manufacturing)
UIP software compatible for customizations
CE, RoHS, REACH and WEEE compliant
Lifetime calibration warranty
Two enclosure sizes for regional acceptance

Sensing Method	Non-dispersive infrared (NDIR) absorption Gold-plated optics Patented ABC Logic self calibration algorithm
CO2 Measurement Range	0 to 2000 ppm (0 ppm = 0 V, 4 mA)
CO2 Accuracy	±30 ppm or 3% of the reading shown, whichever is higher *
Power Supply Requirements	18-30 VAC RMS, 50/60 Hz, or 18 to 42 VDC,polarity protected*AHRAE — regulation 62 states maximum indoor CO2 level of 1000 ppm
Power Consumption	Typical 0.7 W at nominal voltage of 24V AC RMS
Temperature Dependence	0.2% FS per °C (±0.11% per °F)
Stability	<2% of FS over life of sensor (15 years)
Pressure Dependence	0.135% of reading per mm Hg
Certifications	CE EMC, RoHS, REACH and WEEE compliant
Signal Update	Every 5 seconds
CO2 Warm-Up Time	<2 minutes (operational) 10 minutes (maximum accuracy)
Operating Conditions	32°F to 122°F (0°C to 50°C) 0 to 95% RH, non-condensing
Storage Conditions	-40°F to 158°F (-40°C to 70°C)
Flammability Classification	UL94 5VA
Output	Field selectable voltage or current Field selectable voltage or current Voltage only (0-10 or 0-5V)- Current only (4-20 mA)
Analog (CO2)	0 to 5 V, or 0 to 10 V jumper selectable (100 Ω output impedance) Or 4 to 20 mA (RL maximum 500 Ω) Voltage and current outputs are not available simultaneously Digital to analog error ±1%

Telaire T5100 Series